![]() Real-Time Data charts do not display immediately when you add the node/interface because the identification of real-time polling capabilities takes some time, usually it is around 5-10 minutes. Make sure the node/interface is monitored by NPM for a few minutes. If you can see real-time data there, you should be able to see real-time data on the real-time chart. If there is no data to display, real-time charts are not displayed. I cannot see the real-time chart on my node/interface details page Real-time charts show data for a constant time frame of ten minutes. When you leave the page, real-time polling stops in 120 seconds. By default, the data is updated every two seconds. ![]() When you open a page with a real-time chart, real-time polling starts automatically. To see Percent Utilization, open an interface details view.To see CPU Load & Memory Usage, go to a node details view and click the Vital Stats subview.Percent Utilization - Real Time Date (Interface Details view).CPU Load & Memory Usage - Real Time Data (Node Details view, Vital Stats).The following charts support featured data in real time: Records show all 11 have been filed but no additional actions were listed.Observe real-time data for nodes and interfaces on charts SJR 9 is just one of nearly a dozen bills introduced for the current legislative session, according to online records: seven aim to leave the decision up to voters and the remainder call for daylight saving time to be observed year-round. If the resolution were to reach the ballot, and voters were to approve it, all of Texas – which is separated into two different time zones – would observe standard time (the time between November and March) year-round. Recently-introduced Senate Joint Resolution 9, for example, would leave the decision of whether to end daylight saving in the Lone Star State up to voters in November. Yet again, legislators are hoping to eliminate clock-changing across Texas. ![]() In 2019, legislators proposed letting voters decide on the state’s permanent time.Īccording to a tally by the NCSL, 11 pieces of clock-changing legislation failed to pass in Texas in 2021. Three bills were filed in 2017 to keep Texas on central standard time year-round, including a bill filed by Flynn. Where did Whataburger’s orange and white colors come from? It failed to pass amid concerns doing so would make residents choose between going to church and watching the Dallas Cowboys. There was the bill drafted in 2014 by then-Representative Dan Flynn, R-Canton, that would have made Texas observe daylight saving time year-round. In recent years, Texas lawmakers have introduced a number of bills to stop changing the clocks – some hope for permanent standard time, while others call for permanent daylight saving time. According to records, a new bill regarding daylight saving time has yet to be introduced during the current Congress. It was sent to the House of Representatives in March, but no action was taken on it. The bill would make daylight saving time our normal time, effective in early November 2023. Last year, the Senate passed the Sunshine Protection Act of 2021, introduced by Senator Marco Rubio (R-Fla.). Pending federal action could also send states one way or the other on the time-change argument.
0 Comments
Leave a Reply. |